1- Verification of inputs

Here are the checks that should be conducted before submitting simulation jobs to HPC:

Rupture 

1. Test: Extract Mw for all ruptures from SRF.info and plot them versus the Leonard relationship (2011- Table 6).
   Pass criterion: if all the data sits on the one-to-one line, the magnitude of SRFs are correct.
   
   Note: Make sure stable continental region (SRC) of is NOT used. Only use DS and SS equations from of Table 6 of  Leonard (2011).
   Note: SRF.info contains this information (File Formats Used On GM)
   
   
2. Test: Plot number of realizations for a given fault based on its magnitude versus the number of the SRF files exists in the corresponding directory for that given fault.
   Pass criterion:  if the values sit on the one-to-one line, the number of realizations are correct.
   
   
3. Test: Plot lower seismogenic depth of a given fault from national hazard model (Stirling et al 2012) versus the same value from SRF.info (i.e. dbottom).
   Pass criterion: this should be 

• Number of realizations for a given fault based on its magnitude (cross check with the matlab code for number of realizations)
• Read SRF.info file for the generated SRFs and write the files into a text file for all of them
• Compare the output of  SRF.info for all with the matlab code results 

2- Velocity model:

3- Simulation:

4- 

2- Outputs from simulation 

Here are the checks on the obtained results from simulations:

1-