Here are the verifications we considered via automated job submission:

  1. High-frequency:

    For ASCI mode: The number of acceleration files should be 3 times the number of stations. The size of the files for all stations should be equal because the dt value is the same for all stations.
    for Binary mode: Checks whether the hf.bin exists. The number of acceleration files should be 3 times the number of stations. Checks whether all stations have Vs values.

  2. Low-frequency: Checks whether each Rlog is tagged as finished.

  3. Winbin_aio: The number of velocity files should be 3 times the number of stations. The size of the files for all stations should be equal because the dt value is the same for all stations.

  4. Merge-ts: checks whether xyts file (which is used for creating animation) exists.

  5. Merging HF and LF: 

    For ASCI mode: The number of acceleration files should be 3 times the number of stations. The size of the files for all stations should be equal because the dt value is the same for all stations.
    For Binary mode: Checks if the hf.bin exists. The number of acceleration and velocity files should be 3 times the number of stations. Checks whether all stations have Vs values.

  6. simulation Config:  check whether the ingredients of the config files are correct for the given version, namely:
    station file path, 1D velocity model, dt for LF, dt for HF.

    note: dt for LF and HF can be different, but the dt for LF should be equal to dt and consistent with verification for the input (see input verification page dt < 0.495 * hh / V_max from Graves 1996 )
     

  7. IM calc: Check is whether .info file exists. If IM calc is done successfully, there will be .csv (which contains the calculated IM) and a .info file.


    Items to be added for CS 18.9 version:


  8. Run "install simulations" based on the selection file used to generate SRF and VM rather than the VM list created based on existing VMs in the source folder.

 

  • No labels