This page provides rough outlines on the current progress on Cybershake in NZ.

Note that his page is for internal sharing purposes only, it is likely inaccurate and out-of-date, and therefore it is advised to conduct researchers directly if you want more reliable information

Version	Num sources	SRF generation	VM domain	VM generation	Simulation specs	Estimated core-hours	Notes
v17.8	15 (dominant in Canterbury)	vX.XX rupgenerator 3 hypo and 2 slip dist per source	automated based on PGV>5cm/s; 15kmRup, 5km land cutoff Default depth and duration scaling	0.4km regular grid, Vs_min=500	Transition freq = 0.25Hz	~3k Fitzroy	First implementation; Focus on running workflow and comparison with empirically-derived hazard curves
v17.9 (planning)	~100 (dominant in Canterbury, but most of Sth Island)	hypo every X km along strike, Y slip dist per source	automated for PGV>5cm/s ... Improved depth scaling	as for v17.8	as for v17.8	~30k Fitzroy	Focus on extending number of sources and srf uncertianties
v17.10	~100 (Canterbury)	?	as for v17.9	0.2km regular grid, Vs_min=500	Transition frequency = 0.5 Hz	~170k Fitzroy	Focus on improved freq transition in South Island
v17.11	~540 (all in NZ)	?	as for v17.9	as for v17.8	as for v17.8	~500k Fitzroy(?)	Focus on producing NZ-wide output at lower freq transition

Verification process:

Fault rupture (SRF) files:

Source plot on the map
Length-dependent hypocenter location (done)
Different slip distribution realizations (done)

Velocity model (VM) files:

Velocity model plot on the map (done)
Rotation and reduction in size to minimize the ocean coverage (done)
Generate a code to check VM files (done)

1. Check if given VM parameter (folder path) exists
2. .p, .s, .d and params_vel.py files must exist
3. warns if model_params/coords/bounds etc don't exist using params_vel sufx in filename
4. params_vel matching hh/xlen vs nx for x, y, z
5. file size = nx * ny * nz * 4 bytes, checked for .p, .s, .d
6. if numpy available: checks first xz slice for >0 and not NaN in .p, .s, .d

Simulation process:

Verification code for params file for SRF and VMs (e.g., transition frequency, grid size) (in-progress)
Config file for batch submission of the runs (in-progress)
Wall clock and number of cores (in-progress)
Checking if the runs for LF. HF, and BB are done successfully