Configuration change required post earthquake

Note: this is now the permanent configuration

May 2011

Post earthquake the Datastream gateway computer has been repaired and is in a temporary location. However, for better long-term security a new virtual gateway has been created.

If you have Datastream software on your PC, you will need to make one change to use the new gateway.

• Open Datastream
• Select from the top menu bar, Tools
• Choose the option about 1/3^rd of the way down called Configure Communications
• Select the middle tab, Communications
• Click on the button called Config (shown below)

• Change the IP number to 132.181.7.177 as shown in the following screen shot)

• Click OK and again and Datastream should now connect.