Page History

...

1. After admin tells you that all files are uploaded to Fitzroy, Run setup_remote.sh
   $ setup_remote.sh username
   e.g $ setup_remote.sh jonney
2. Copy the path provided, it will be the path for your simulation on Fitzroy
3. d

6. Run the simulation

6. Run the simulation on Low Frequency (LF)

1. Go to the Simulation Folder, located at /nesi/projects/nesi00213/RunFolder/user/run_name
   e.g. $ cd /nesi/projects/nesi00213/RunFolder/ykh22/20100904_Darfield_m7p1_201705181350
2. Run submit_emod3d.sh
   $ ./submit_emod3d.h
3. It will ask you to enter a wall_clock_limit and if it should auto submit the job.
   note: if you prefer to change some detail configurations, press 2(no) for auto submit.
4. Use llq to check if your job has finished. (job status: R= running, C= Complete, I = idle)
   $ llq -u user
5. After Emod3d finished, run submit_post_emod3d.sh
   note: if you prefer to change some detail configurations, press 2(no) for auto submit.
   $ ./submit_post_emod3d.sh

7. Run the simulation on High Frequency (HF)

note: this part can run before LF is finished

1. Run install_bb.sh, to setup the parameters
   $ ./install_bb.sh
2. Choose from the options according to simulation requirement
3. Run submit_hf.sh
   $ ./submit_hf.sh
   note: if you prefer to change some detail configurations, press 2(no) for auto submit.

8. Run the Simulation on Broad Band (BB)

Note: This part MUST wait untill both LF and HF are finished

1. Run submit_bb.sh
   $ ./submit_bb.sh
2. d
3. d
4. d
5. d
6. d
   
   
   
   
   

Related articles

...