...
- Conduct manual verification of the existing IM plots from simulation
- Run empirical IM and ratio plots for the remaining faults
- Code IM ratio statistical analysis and plot histogram of the ratio for further investigation
- Conduct manual verification of the existing IM plots
- Run IM aggregate and hazard calc for SA(5.0) as an example case
- Verify the hazard curves as the code has changed again
- Run hazard calcs for CS18.6 for all IMs existing empirical PSHAs
- Compare hazard curves and hazard maps for 18.6 and 18.5
- Fill in the draft paper with updated results
- Review and revise – and send to Brendon for review
- Conduct hazard calculations via python code and compare with the openSHA results
...
- Identify source parameters that can be considered in the list of variable parameters for source generation (beside besides Mw)
- Investigate the correlation structure between the chosen parameters
- Set up the SRF generation code to include these parameters
- Generate SRF and VM
- Run verification test on them (both via verification code + manual checks)
- Run GM sim via new workflow
- Run IM verification code + do a manual verification
- Plot IMs
- run Hazard calc
- Compare results from the previous steps with the empirical and previous versions of cybershake runs
...