...
6. Run the simulation on Low Frequency (LF)
Go to the Simulation Folder, located at /nesi/projects/nesi00213/RunFolder/user/run_name
e.g. $ cdCode Block language bash $ cd /nesi/projects/nesi00213/RunFolder/ykh22/20100904_Darfield_m7p1_201705181350
Run submit_emod3d.sh
$ ./submit_emod3d.hCode Block language bash It will ask you to enter a wall_clock_limit and if it should auto submit the job.
note: if you prefer to change some detail configurations, press 2(no) for auto submit.*Code Block language bash use llsubmit to submit your job if you selected to not to auto submit.
Code Block language bash Use llq to check if your job has finished. (job status: R= running, C= Complete, I = idle)
$ llq -u userCode Block language bash After Emod3d finished, run submit_post_emod3d.sh
note: if you prefer to change some detail configurations, press 2(no) for auto submit.*
$ ./submit_post_emod3d.shCode Block language bash
7. Run the simulation on High Frequency (HF)
note: this part can run before LF is finished
Run install_bb.sh, to setup the parameters
$ ./install_bb.shCode Block language bash Choose from the options according to simulation requirement
Code Block language bash Run submit_hf.sh
$ ./submit_hf.sh
note: if you prefer to change some detail configurations, press 2(no) for auto submit.*Code Block language bash
*: use llsubmit to submit your job if you selected not to auto submit. $ llsubmit job.ll
...
Note: This part MUST wait untill both LF and HF are finished
Run submit_bb.sh
$ ./submit_bb.shCode Block language bash
Info |
---|
Related articles
Content by Label | ||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...