Configuration change required post earthquake
Note: this is now the permanent configuration
May 2011
Post earthquake the Datastream gateway computer has been repaired and is in a temporary location. However, for better long-term security a new virtual gateway has been created.
If you have Datastream software on your PC, you will need to make one change to use the new gateway.
- Open Datastream
- Select from the top menu bar, Tools
- Choose the option about 1/3rd of the way down called Configure Communications
- Select the middle tab, Communications
- Click on the button called Config (shown below)
- Change the IP number to 132.181.7.177 as shown in the following screen shot)
- Click OK and again and Datastream should now connect.